PENTAIR DYNA-JET

Spa/Water Features Pump

THE HEART OF YOUR POOL'S CIRCULATION SYSTEM

For residential/commercial use, indoor or outdoor installation. A spa and water features pump in the Sta-Rite tradition of Dura-Glas® pumps. Precision-molded of a proprietary blend of glass-reinforced thermoplastic that is highly corrosion resistant. Ideal pump where warm water service, high flow, and quiet operation are required.

SKU: TPEAE-165L, TPEAF-166L , TPEAG-167L, TPEAAG-168L, TPRAF-174L, TPRAG-175L, TPEAYG-175L , TPEAAYG-168L Categories: , Tag:

 

PENTAIR DYNA-JET

INSTALLATION

  • Only qualified, licensed personnel should install pump
    and wiring.
  • Pump mount must:Be solid – Level – Rigid – Vibration free. (To reduce vibration and pipe stress, bolt pump to mount.)
  • Install pump with suction port below water level (flooded suction) only. Pump does not lift water.
  • Allow use of short, direct suction pipe (To reduce friction
    losses).
  • Allow for gate valves in suction and discharge piping.
  • Have adequate floor drainage to prevent flooding.
  • Be protected from excess moisture.
  • Fittings:
    • Fittings restrict flow; for best efficiency use fewest
      possible fittings.
    • Avoid fittings which could cause an air trap in suction
      piping.
    • Pool and spa drains must conform to Internationa
    • Association of Plumbing and Mechanical Officials (IAPMO) standards.
    • Use only non-entrapping suction fittings and dual suction outlets.

    Voltage
    * Voltage at motor must be not more than 10% above or below motor nameplate rated voltage or motor may
    overheat, causing overload tripping and reduced component life. If voltage is less than 90% or more than 110% of rated voltage when motor is running at full load, consult power company.

Related products