- Built-in front rotating brush deep cleans stubborn dirt
- Cleans continuously in both forward and reverse modes
- 40% larger vacuum intake to take on debris of all shapes and sizes
- Nearly 1/3 more cleaning power
- Exclusive, self-powered Night Cruize® LED lights add ambiance and intrigue to nighttime cleaning
Assembling the Cleaner
- Attach the Quick Connect fitting on the end of the hose to the feed tube on the RACER Pressure Side Pool Cleaner. Be sure the snaps are engaged
- Attach the debris bag to the cleane. Push the bag over vacuum tube to click it into place
- Reviw checklist before use:
- Hoses cut properly and floats evenly spaced.
- Mender nuts are tight on feed hose
- Wall fitting secure and in place
- Debris bag and hose assembly attached
- Ensure debris seal is attached
Using the Cleaner
- Lower the cleaner carefully into pool
- Switch ON the FILTER PUMP
- Wais at least 60 seconds to allow air to blow out of the hose
- Switch ON the BOOSTER PUMP
Cleaning the Debris Bag
1. Detach the bag strap from the hose.
2. Press the release button on the cleaner vacuum tube and carefully pull up to remove the bag from the cleaner.
3. Open bag closure by pulling apart the fabric tabs at the top of the bag. Holding the bottom
of the bag, turn over to empty debris out of the top. If needed, rinse bag with a hose.
4. To close, press together the hook and loop fabric at the top of the bag and run finger along entire length of
bag so it is completely closed.
5. Be sure debris seal is on the vacuum tube. See figure 12 on page 6.
6. Slide the debris bag collar over the vacuum tube until it clicks in place.
7. Reattach the strap onto the feed hose.
8. To keep bag from folding during operation, attach the strap above first feed line float. Slide float down if needed.